Skip to content
WS Painting & Remodeling
Call

Siding Replacement in Marietta, GA

Marietta spans a century and a half of building, which is why one street can need careful sash and trim work and the next needs a full kitchen gut. Work around the Square and in the historic districts runs slower by design — older substrates, lead-era coatings and more prep than a modern subdivision ever asks for.

Cobb County · about 22 minutes from our Powder Springs shop

Get a free estimate

Step 1 of 3

What do you need? * Pick all that apply

Free and no obligation. We never sell or share your details.

Siding Replacement for Marietta homes

Everything from antebellum and Victorian homes near the Square, through mid-century ranches, to 80s and 90s brick-and-siding subdivisions in East Cobb. Older homes need genuine carpentry repair before any topcoat; the East Cobb stock is squarely in kitchen-and-bath remodel territory.

Areas we work in Marietta

  • Marietta Square
  • Whitlock Heights
  • East Cobb
  • Kennesaw Avenue Historic District
  • Church-Cherokee
  • Sibley Forest

Near Marietta Square, Kennesaw Mountain, The Strand Theatre and across the rest of Marietta.

Siding Replacement on Marietta houses

Marietta is the one market where siding replacement is rarely a whole-house job. The 80s and 90s subdivisions in East Cobb are brick-and-siding mixes — brick across the front and first floor, with lap siding or wood on the gables, dormers, upper story and the sides, where cladding was cheaper than laying more brick. Those clad sections are where the failure shows, so replacement is usually partial: the gable and upper-story board comes off while the brick stays put. Closer to the Square and the historic districts the homes wear real cedar and wood clapboard. Cedar is worth repairing rather than wholesale replacing — it is solid wood with decades left once the rot is cut out and pieced in — and in a historic district the original profile matters, so a like-for-like repair beats swapping in a modern product.

What usually gets missed

On the brick-and-siding houses the detail that gets botched is the transition where siding meets brick and where the gable board ties into the roofline — water sheds off the brick and finds the clad section, and if the flashing and the kick-out at the roof-wall joint are not right, the new siding rots at the same spot the old boards did. On the cedar homes the mistake is condemning a whole wall when only the bottom courses and a few sun-split boards are gone. Good cedar splices cleanly, and tearing off sound, decades-old wood to save a day of carpentry is the wrong trade.

On a Marietta job we check

  • Flash the siding-to-brick transition and roof-wall kick-outs properly.
  • Splice in sound cedar instead of a full tear-off.
  • Match profile and reveal when patching existing clad gables.

5.0 from 44 Google reviews. Dan James walks every finished job.

Get a free estimate

Step 1 of 3

What do you need? * Pick all that apply

Free and no obligation. We never sell or share your details.

(470) 419-0922

What the job actually involves

Siding is a weather barrier, and what sits behind it matters as much as what you see. Replacement is the chance to find and fix hidden water damage, flash windows properly, and put the wall back together right.

We use a lapped weather barrier, metal and tape flashing at openings, and corrosion-resistant fasteners, because siding itself only works as part of that water-shedding system behind it.

How we run a siding replacement job in Marietta

  1. 1

    Inspect and choose material

    We check the existing siding, sheathing and trim for rot, moisture and insect damage, and talk through options: vinyl, fiber cement, engineered wood and others. Each has different costs, upkeep and installation needs.

  2. 2

    Remove old siding and check the wall

    Old siding comes off and we look at the sheathing underneath. Rotted sheathing and framing are replaced. This is where hidden water damage turns up, often around windows and below roof lines.

  3. 3

    Install weather barrier and flashing

    House wrap or building paper goes on, lapped so water sheds outward. Windows, doors and penetrations are flashed with tape and metal, which is the detail that keeps water out for the long run.

  4. 4

    Hang siding

    Siding goes up from the bottom, level, with the manufacturer's nailing and gap requirements followed. Vinyl needs room to expand in Georgia summer heat, so it is not nailed tight. Fiber cement is cut with proper dust control.

  5. 5

    Trim, corners and sealing

    Corner boards, window and door trim, and soffit and fascia details are installed and caulked with the right sealant. Fiber cement and wood are primed and painted.

  6. 6

    Cleanup and walkthrough

    Old siding, nails and scraps are hauled off, and we run a magnet over the yard for nails. We walk the house with you before closing out.

What moves the price

We will not quote Marietta blind over the phone — these are the things we look at on site that decide the number.

  • House size and number of stories, including gables.
  • Siding material and trim package.
  • Sheathing or framing repairs discovered after removal.
  • Number of windows, doors and architectural details to flash and trim around.
  • Whether soffit, fascia, gutters or insulation are included.
  • Painting, if the material is not factory-finished.
See typical siding replacement price ranges →

From a siding replacement customer

“We totally gutted THREE, 40+ year old bathrooms, and the results are INCREDIBLE! … There was intricate tile work required and they delivered impeccable results!”
shannon mcswain
Three bathroom gut renovations
All 44 reviews →

Want a real number for your Marietta siding replacement job?

The only way to price it honestly is to see it. We come out, walk the job and put it in writing — free, and with no obligation to book.

Call and we answer 24/7. Forms sent during the day get a call back the same day.

Siding Replacement in Marietta — questions we get asked

How long does siding replacement take?
A typical house takes about one to three weeks of work, depending on size, material and weather. Rot repair or complex trim can extend it.
Will I be able to stay in the house?
Yes. It is noisy outside, and we keep walls closed up each day so the house is weathertight at night.
Which siding holds up best in Georgia?
Fiber cement and quality vinyl both do well. Humidity, sun and termites matter in the choice. We explain the tradeoffs and what upkeep each needs.
Do I need a permit?
In some jurisdictions yes. We tell you what applies to your address.
Can you just fix damaged sections?
Sometimes. If the damage is limited and a match is available, a repair can make sense. If the siding is aging across the house, replacement is often the better call.

Prefer to talk it through? Dan picks up.

(470) 419-0922
Call (470) 419-0922 Free Estimate