Bathroom Remodeling in Atlanta, GA

What this job actually involves

Water is the thing that wrecks bathrooms. A good remodel is mostly waterproofing, ventilation and slope, with the visible tile and fixtures coming after.

How the work runs

1. 1 Demo and inspect for water damage Old tile, tub, vanity and flooring come out down to the framing. We check the subfloor and wall studs for soft spots and rot, which are common around old tubs and toilets in humid climates.
2. 2 Repair framing and rough-in plumbing and electrical Rotted wood is replaced, plumbing is moved or updated, and wiring and fan circuits are brought up to date. Permitted work gets inspected at this stage.
3. 3 Waterproof the wet areas Cement board or a foam backer goes up in showers and tub surrounds, and seams are sealed with a waterproofing membrane. Shower pans are sloped toward the drain and flood-tested before tile when the setup calls for it.
4. 4 Tile and flooring Tile is set over a flat surface with the proper thinset and given time to cure before grouting. Rushing grout over wet thinset leads to cracks and loose tile.
5. 5 Vanity, fixtures, ventilation and paint The vanity, toilet, faucets and lighting are installed. A working exhaust fan vented outside matters in Georgia humidity, otherwise mildew returns. Paint uses a moisture-resistant finish.
6. 6 Seal, clean and walk through Grout is sealed where needed and silicone goes at corners and tub lines. We clean up and go through the room with you.

What moves the price

• Size of the bathroom and whether the layout stays the same or fixtures move.
• Shower or tub choice: standard tub, tiled shower, curbless or walk-in.
• Tile type, pattern and amount. Detailed patterns and large-format tile need more labor.
• Hidden damage, mostly rot in the subfloor and walls.
• Vanity, countertop and fixture quality.
• Plumbing, electrical and ventilation upgrades, including permits.

What does this actually cost? Real metro-Atlanta price ranges and what moves them — no email required. →

Materials

We use cement board or a waterproof backer, a sealed membrane in showers, and mildew-resistant caulk and paint, because the finish layers only last if the water is kept out of the walls and floor.

Questions we get asked

How long will my bathroom be unusable?

A typical hall bath often takes a couple of weeks, sometimes longer for a full master bath or custom tile. Drying and curing time is part of that.

Do I need a second bathroom while you work?

It helps a lot. If this is your only bathroom, tell us and we will plan to shorten the time it is out, or discuss options.

Do you handle the plumbing?

We coordinate plumbing and electrical work and any required permits and inspections.

Can you convert a tub to a shower?

Yes, in most layouts. It involves changing the drain, framing and waterproofing, so it costs more than swapping a fixture.

What if you find rot?

We show you, explain the repair, and price it before continuing. It is common in older bathrooms and should be fixed rather than covered.