Skip to content
WS Painting & Remodeling
Call

Cabinet Painting & Refinishing in Kennesaw, GA

Kennesaw sits about 28 minutes north of the shop, the first market up the Cobb Parkway corridor past the usual west-metro run. It spent most of its history as a small railroad town and then filled in fast — the population roughly tripled between 1990 and 2010 as wooded subdivisions went up off Cobb Parkway and around Kennesaw State. That history is why the work here is weighted toward painting: acres of 1980s-through-2000s builder stock all reaching their repaint years on the same clock, rather than the old-substrate remodeling that drives the older Cobb towns.

Cobb County · about 28 minutes from our Powder Springs shop

Get a free estimate

Step 1 of 3

What do you need? * Pick all that apply

Free and no obligation. We never sell or share your details.

Cabinet Painting & Refinishing for Kennesaw homes

The stock is overwhelmingly suburban and built in one long wave — 1980s through early-2000s subdivisions off Cobb Parkway and Stilesboro Road, with Legacy Park and Summerbrooke typical of the mid-to-late-90s build-out. That means builder-grade exteriors aging on one schedule: hardboard and Masonite lap siding swelling and delaminating at the butt joints and bottom courses in Georgia humidity, early fiber-cement that needs real prep and re-caulking, brick fronts with sided gables and rear walls, and the synthetic-stucco and stone-veneer accents on the golf-community homes, which have to be checked for moisture before anything goes over them. These are repaint jobs on a cycle — chalked coatings, failed caulk lines and south-and-west sun damage — and the pressure-treated pine decks that came with the houses are due to be stripped and restained. Inside, the two-story foyers and open great rooms of this era read as high-wall and stairwell work, and the older subdivisions still have popcorn ceilings to pull. The exception is a small, genuinely old core around the downtown depot — wood-frame houses from the late 1800s into the 1920s, weatherboard and wood sash — that needs carpentry and prep before a topcoat, plus scattered 1960s-70s brick ranches near Pinetree with trim, soffit and eave repair of their own.

Areas we work in Kennesaw

  • Downtown Kennesaw
  • Legacy Park
  • Pinetree Country Club
  • Summerbrooke
  • East Park Village

Near Southern Museum of Civil War and Locomotive History, Depot Park, Swift-Cantrell Park and across the rest of Kennesaw.

5.0 from 44 Google reviews. Dan James walks every finished job.

Get a free estimate

Step 1 of 3

What do you need? * Pick all that apply

Free and no obligation. We never sell or share your details.

(470) 419-0922

What the job actually involves

Cabinets get touched, splashed and scrubbed every day, so the finish has to be hard and well bonded. That comes from degreasing, scuff-sanding and the right primer, not from a coat of wall paint.

We use a bonding primer and a hard-curing cabinet enamel rather than wall paint, because cabinets take constant handling and moisture, and ordinary paint stays soft and scuffs.

How we run a cabinet painting & refinishing job in Kennesaw

  1. 1

    Label and remove doors and hardware

    Doors, drawer fronts and hinges are taken off and numbered so everything returns to its original spot. Hardware is bagged. Drawer boxes and cabinet frames stay in the house and get masked.

  2. 2

    Degrease and deep clean

    Years of cooking residue sit on cabinet faces, especially near the stove. We clean with a degreaser, then rinse. Paint over grease will peel off in sheets, so this step is not skipped.

  3. 3

    Repair, sand and fill

    Dings, old hardware holes and gouges are filled. All surfaces are sanded to dull the existing finish. Open-grain wood such as oak may get grain filler if you want a smooth look, otherwise the grain will show through.

  4. 4

    Prime with a bonding primer

    A stain-blocking bonding primer goes on to seal tannins and grip old finishes. Dark or stained cabinets can bleed through, which is why primer matters.

  5. 5

    Sand lightly and apply finish coats

    We scuff the primer, then apply two coats of a hard cabinet enamel by spray or fine roller and brush, with drying time between coats. Humid weather slows this down and can leave a soft film, so we manage airflow and timing.

  6. 6

    Cure, reinstall and adjust

    Doors are rehung after the finish has dried enough to handle, and hinges and doors are adjusted so they close squarely. New or original hardware goes back on. The paint keeps hardening for days to weeks, so go gently at first.

What moves the price

We will not quote Kennesaw blind over the phone — these are the things we look at on site that decide the number.

  • Number of doors and drawer fronts, which drives most of the labor.
  • Condition and material. Water-damaged, peeling or heavily worn cabinets need repair.
  • Wood species and grain. Oak and similar open-grain wood takes extra work to look smooth.
  • Whether we paint cabinet interiors and the end panels and toe kicks.
  • Color change. Dark to light usually needs more primer and coats.
  • Whether doors are sprayed off-site or in a controlled space versus painted in place.
See typical cabinet painting & refinishing price ranges →

From a cabinet painting & refinishing customer

“Quick and responsive customer service Great final project. We are thrilled with our results. We went from dark wood cabinets to cream with new hardware and an accent island.”
Audrey Jinks
Cabinet painting and island
All 44 reviews →

Want a real number for your Kennesaw cabinet painting & refinishing job?

The only way to price it honestly is to see it. We come out, walk the job and put it in writing — free, and with no obligation to book.

Call and we answer 24/7. Forms sent during the day get a call back the same day.

Cabinet Painting & Refinishing in Kennesaw — questions we get asked

How long are my kitchen cabinets out of commission?
Plan on about a week for a typical kitchen, sometimes a bit more. Doors may be gone for several days while they are painted and dry. You can still use the kitchen sink and appliances, but the cabinets themselves are partly unusable.
Will the paint chip?
Any painted surface can chip, especially at edges and around handles. Proper cleaning, sanding and primer, plus a hard enamel, cut that risk a lot. The finish continues to cure for weeks, so be gentle at first.
Can you paint cabinets that are already painted or stained?
Yes. Both are fine with proper prep. Laminate and thermofoil are trickier and we will tell you honestly if yours is a poor candidate.
Is painting cheaper than replacing cabinets?
Usually, if the boxes are solid and the layout works for you. If the cabinets are damaged, sagging or badly designed, replacing them may be the better move.
Is there a smell?
Some, during painting and for a day or so after. We use low-odor products where we can and recommend ventilation.

Prefer to talk it through? Dan picks up.

(470) 419-0922
Call (470) 419-0922 Free Estimate