Skip to content
WS Painting & Remodeling
Call

Cabinet Painting & Refinishing in Douglasville, GA

Douglasville is the biggest market inside twenty minutes of the shop, and it is still growing west along the I-20 corridor. The local-pack incumbents here are unusually weak — the top-ranked painter in town has no website at all.

Douglas County · about 18 minutes from our Powder Springs shop

Get a free estimate

Step 1 of 3

What do you need? * Pick all that apply

Free and no obligation. We never sell or share your details.

Cabinet Painting & Refinishing for Douglasville homes

Large 1990s-2010s subdivisions on generous lots, plus older housing around the historic downtown. Volume exterior repaints and deck work dominate; the newer Chapel Hill stock is reaching its first serious repaint cycle.

Areas we work in Douglasville

  • Chapel Hill
  • Arbor Place
  • Bright Star
  • Fairplay
  • Dorsett Shoals

Near Arbor Place Mall, Hunter Memorial Park, Historic O’Neal Plaza and across the rest of Douglasville.

Cabinet Painting & Refinishing on Douglasville houses

Kitchens in Douglasville skew newer, which changes the material more than the color. The big 1990s-through-2010s subdivisions — Chapel Hill, Arbor Place, Bright Star — were built with factory doors, and a lot of them are white thermofoil: an MDF core wrapped in a heat-bonded vinyl skin, not solid wood. You cannot sand a thermofoil skin the way you sand oak, because there is no wood under the surface to key into. It takes a specific bonding primer made for slick factory coatings, and even then the skin near the range can already be peeling from years of oven heat. The boxes behind those doors are usually melamine over particleboard, which also wants a grip primer, never a bare sand that cuts through to the chipboard.

What usually gets missed

The honest conversation on a Douglasville builder kitchen is whether the doors should be painted at all. Thermofoil that is still tight takes paint fine with the right primer, but once the skin has started lifting at a corner or bubbling by the oven, paint will not re-stick it; it only seals the peel. On those, new solid or MDF doors on the existing boxes is the better money. The common failure is a painter treating thermofoil like wood: a scuff-sand tears the vinyl, and a standard primer slides off the slick factory face, so the whole finish lets go within months around the handles and the heat.

On a Douglasville job we check

  • Confirm doors are thermofoil, melamine or wood before quoting prep
  • Bonding primer made for slick factory skins, never a bare sand
  • Peeling skin by the oven means new doors, not paint

5.0 from 44 Google reviews. Dan James walks every finished job.

Get a free estimate

Step 1 of 3

What do you need? * Pick all that apply

Free and no obligation. We never sell or share your details.

(470) 419-0922

What the job actually involves

Cabinets get touched, splashed and scrubbed every day, so the finish has to be hard and well bonded. That comes from degreasing, scuff-sanding and the right primer, not from a coat of wall paint.

We use a bonding primer and a hard-curing cabinet enamel rather than wall paint, because cabinets take constant handling and moisture, and ordinary paint stays soft and scuffs.

How we run a cabinet painting & refinishing job in Douglasville

  1. 1

    Label and remove doors and hardware

    Doors, drawer fronts and hinges are taken off and numbered so everything returns to its original spot. Hardware is bagged. Drawer boxes and cabinet frames stay in the house and get masked.

  2. 2

    Degrease and deep clean

    Years of cooking residue sit on cabinet faces, especially near the stove. We clean with a degreaser, then rinse. Paint over grease will peel off in sheets, so this step is not skipped.

  3. 3

    Repair, sand and fill

    Dings, old hardware holes and gouges are filled. All surfaces are sanded to dull the existing finish. Open-grain wood such as oak may get grain filler if you want a smooth look, otherwise the grain will show through.

  4. 4

    Prime with a bonding primer

    A stain-blocking bonding primer goes on to seal tannins and grip old finishes. Dark or stained cabinets can bleed through, which is why primer matters.

  5. 5

    Sand lightly and apply finish coats

    We scuff the primer, then apply two coats of a hard cabinet enamel by spray or fine roller and brush, with drying time between coats. Humid weather slows this down and can leave a soft film, so we manage airflow and timing.

  6. 6

    Cure, reinstall and adjust

    Doors are rehung after the finish has dried enough to handle, and hinges and doors are adjusted so they close squarely. New or original hardware goes back on. The paint keeps hardening for days to weeks, so go gently at first.

What moves the price

We will not quote Douglasville blind over the phone — these are the things we look at on site that decide the number.

  • Number of doors and drawer fronts, which drives most of the labor.
  • Condition and material. Water-damaged, peeling or heavily worn cabinets need repair.
  • Wood species and grain. Oak and similar open-grain wood takes extra work to look smooth.
  • Whether we paint cabinet interiors and the end panels and toe kicks.
  • Color change. Dark to light usually needs more primer and coats.
  • Whether doors are sprayed off-site or in a controlled space versus painted in place.
See typical cabinet painting & refinishing price ranges →

From a cabinet painting & refinishing customer

“His crew and him, helped me and the family get our home painted and repairs that look like new. … He ended up replacing trim and sills around my home.”
Guti Guti
Exterior repaint, trim and sills
All 44 reviews →

Want a real number for your Douglasville cabinet painting & refinishing job?

The only way to price it honestly is to see it. We come out, walk the job and put it in writing — free, and with no obligation to book.

Call and we answer 24/7. Forms sent during the day get a call back the same day.

Cabinet Painting & Refinishing in Douglasville — questions we get asked

How long are my kitchen cabinets out of commission?
Plan on about a week for a typical kitchen, sometimes a bit more. Doors may be gone for several days while they are painted and dry. You can still use the kitchen sink and appliances, but the cabinets themselves are partly unusable.
Will the paint chip?
Any painted surface can chip, especially at edges and around handles. Proper cleaning, sanding and primer, plus a hard enamel, cut that risk a lot. The finish continues to cure for weeks, so be gentle at first.
Can you paint cabinets that are already painted or stained?
Yes. Both are fine with proper prep. Laminate and thermofoil are trickier and we will tell you honestly if yours is a poor candidate.
Is painting cheaper than replacing cabinets?
Usually, if the boxes are solid and the layout works for you. If the cabinets are damaged, sagging or badly designed, replacing them may be the better move.
Is there a smell?
Some, during painting and for a day or so after. We use low-odor products where we can and recommend ventilation.

Prefer to talk it through? Dan picks up.

(470) 419-0922
Call (470) 419-0922 Free Estimate